Insulation in Fresno, TX

Sugar Land Spray Foam does insulation work for homes and small buildings in Fresno, Texas. We are based in Sugar Land and drive out to Fresno for estimates and jobs. Call (346) 279-1295 or send a request and we will set up a visit.

What insulation work looks like in Fresno

Fresno sits in eastern Fort Bend County, south of Houston, with Missouri City to the northwest, Arcola to the south and Pearland to the east. A lot of its housing grew up during the 1970s and 1980s, when the area was pulled along by the growth of Houston. Homes from that stretch were often built with thin batts in the attic and little attention to air leaks. If you own one, the insulation you have today may be compressed, uneven or simply not enough.

The Gulf Coast climate puts steady load on any house here. Long hot months mean the attic bakes, and the cooling system works against that heat all day. Mild, damp winters add moisture to the picture. Good insulation in this part of Texas is mostly about slowing heat gain, sealing the gaps where hot, humid air leaks in, and keeping wet or dirty material out of the living space.

Spray foam insulation for Fresno homes

Spray foam insulation is the option we recommend most often when a house has leaky framing or a roofline that is hard to insulate any other way. It expands to fill gaps, so it insulates and air seals in one pass.

Open-cell and closed-cell foam

Open-cell foam is softer and lighter. It works well on the underside of a roof deck or inside walls where you want a good air seal without the extra density. Closed-cell foam is rigid and denser, adds some strength to the surface it is sprayed on, and resists moisture better. That makes it a common choice for crawl spaces, garages and metal buildings.

Other foam jobs we take on

Beyond houses, we spray metal buildings, new construction framing and commercial spaces. Metal buildings sweat when warm air meets a cold steel surface, and foam stops that by covering the steel directly. Crawl space work is less common in Fresno, but we do it where a home sits on a pier and beam foundation.

Attic insulation and air sealing

For most Fresno homeowners the attic is where the money goes. Heat that builds up under the roof works its way down through the ceiling into the rooms below. Attic insulation fixes that, and the right method depends on what is already up there.

Blown-in insulation

Blown-in fibreglass or cellulose is a practical way to bring an older attic up to a better level. It covers the joists evenly, wraps around wiring and framing, and can be added over existing material that is still dry and in decent shape.

Air sealing, ventilation and radiant barrier

Before new material goes down, we look at the gaps around can lights, plumbing stacks, wiring holes and the attic hatch. Sealing those first keeps conditioned air from escaping into the attic. We also check attic ventilation, because trapped heat and moisture shorten the life of both the insulation and the roof. A radiant barrier can be added under the roof deck to reflect some of the radiant heat before it reaches the attic floor. Duct insulation is worth a look too, since leaky or bare ducts in a hot attic lose a lot of the air you paid to cool.

Wall insulation, garages and sound control

Walls are harder to deal with than attics, but they matter. Wall insulation covers batt insulation in open framing, such as during a remodel or an addition, and denser products where you want to cut noise between rooms.

Garages are a frequent request. An attached garage with bare studs and an uninsulated door wall passes heat straight into the house. Insulating it and sealing the shared wall makes the adjoining rooms easier to keep comfortable. Soundproofing insulation between a bedroom and a busy living area or a home office is a smaller job that people often find worth doing.

Insulation removal and cleanup

Sometimes the right move is to take the old material out. Insulation that has been soaked by a roof leak, matted down, chewed by rodents or soiled by animals will not do its job, and it can leave odours in the house. We handle insulation removal, attic cleaning and sanitizing, and rodent proofing so the new material is not laid over a problem. We also remove spray foam when it was installed badly or needs to come out for repairs. Tell us what you see and we will look at it before suggesting anything.

About Fresno: Fresno, TX on Wikipedia · Fresno on Google Maps